Matrix A7xi Spécifications télécharger pdf (Page 113)

110

9.22 TESTING THE ASCENT TRAINER

ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND

PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST

THE MACHINE:

1) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER) and input the serial number of the console. Also set the Machine Type (ENTER, 3, 0, 0, 2,

ENTER) and verify that the Date and Time are correct (See Section 7.2). note: If he Machine Type setting has been changed, the unit power

should be reset. Cycle the power switch.

2) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER). Then edit Club ID on the Asset Management and Root Path on the Virtual Active

depending on whether the club has these functions.

3) Program the TV channels (see Section 10.5).

4) Without hitting start or entering any exercise modes, stand on the machine and hold the handlebars while initiating movement to simulate

exercising. While moving listen for any odd noises or squeaks.

5) After stopping movement, press the green GO key and begin using the machine.

6) Grasp the hand grips to check for proper heart rate response.

7) Press the LEVEL UP and DOWN keys on the console to make sure resistance is fully functional.

8) Press the ELEVATION UP and DOWN keys (fully incline and decline the machine) to make sure the incline motor function is fully operational.

9) If the Ascent Trainer has had an incline motor replaced, or if this is the initial installation, calibrate the lift motor (see Section 3.5).

CHAPTER 9: PART REPLACEMENT GUIDE

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 154 155

Pas de commentaire

Matrix A7xi Spécifications Page 113