Matrix A7xi Spécifications télécharger pdf (Page 92)

9.7 PULLEY AXLE SET REPLACEMENT

CHAPTER 9: PART REPLACEMENT GUIDE

1) Turn off the power and disconnect the cord from the machine.

2) Remove both front disks from the machine as outlined in Section 9.1.

3) Loosen the belt tension bolt on the right side until there is enough slack to remove the drive belt (Figure A).

4) On the right side of the frame, remove the retaining clip that holds the pulley axle bearing into the frame (Figure B).

5) On the left side of the frame, remove the retaining ring that holds the pulley axle bearing into the frame (Figure C).

6) Remove the pulley axle set assembly from the frame. Clean any debris from the hole in the frame (Figure D).

7) Reverse Steps 1-6 to install a new pulley axle set. Rotate the pulley to make sure that the motion is smooth and that there is no wobbling to

one side. Re-install the belts as outlined in Sections 9.5 and 9.6.

8) Test the Ascent Trainer for function as outlined in Section 9.22.

FIGURE A

FIGURE B

FIGURE C FIGURE D

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 154 155

Pas de commentaire

Matrix A7xi Spécifications Page 92